One-stop service system from process design to equipment manufacturing, installation and commissioning

Time of release：

2022-05-09

Through the configuration of various parameters in the extrusion process, real-time control of the speed and direction of the motor, the extruder in the automatic speed and pressure control device, and the control method, etc., realize the automatic control of the extrusion speed and pressure, in order to ensure product production. Consistency, improve product qualification rate and production efficiency, copper extrusion equipment has position detection function, extrusion rack and main extrusion rack structure, etc. are configured on the rack, and there is an extrusion die on the right side of the guide rail , There is an extrusion die on the left side of the extrusion die. The material sensor is located on the left side of the extrusion tank, and the electric telescopic rod is located below the material sensor. The main structure of the extruder is above the guide rail, and the PLC controller is set on the front side of the extruder body. There is a front support plate, and there is a support inside the protection cylinder. Rod, copper extrusion machine is equipped with material sensor with tool position detection function, when the material sensor moves to the front of the extrusion box, it can detect whether the inner knife is in position and send a signal to it, when the tool is not in the proper position, The PLC controller can cut off the pressure signal to ensure safe production.